Lift-Up Cooktop; Surface Burners - Whirlpool FGP325A Instruction Book

Lift-up cooktop
1.
Remove surface burner grates.
2. Lift
front of cooktop at both front corners until
the support rods lock into place.
Personal Injury and
Product Damage Hazard
l
Be sure both support rods are fully ex-
tended and in the locked position. Failure
to do so could resuft in personal injury from
the cooktop accidentally falling.
l
Do not drop the cooktop. Damage can
result to the porcelain and the cooktop
frame.
3. Wipe
with warm, soapy water.
Use
a soapy
steel-wool pad on heavily soiled areas.
NOTE:
When cleaning under the cook-top on
standing pilot models, be careful not to
extinguish pilots.
4.
To lower the cooktop, lift
cooktop from both
sides while pressing the support rods back to
unlock them.
Lower
the cooktop into place.
Replace
surface burner grates.
Surface burners
1. Lift up
the cooktop, following the instructions
above.
2.
Before cleaning, remove screws
that hold
each of the burners in place. The screws
prevent the burners from moving during
shipment. Remove the shipping screw with a
Phillips screwdriver,
lift
the burner up, tilt it to
one side at the end closest to the ignitor and
move it toward the back of the range. This
separates the burner from the gas valve at the
front of the range, so it can be easily removed.
3. Wipe
off surface burners with warm, soapy
water and a sponge after each use.
To
remove cooked-on food, soak
the burners in
a vinegar and water solution for
20-30
minutes.
Scrub
with a plastic scrubbing pad.
4. If ports are clogged, clean with a straight
pin.
DO
NOT enlarge or distort the ports.
DO NOT use a toothpick to clean the ports.
Screws
17