Whirlpool 8053373A Use And Care Manual page 10

USING YOUR RANGE
T
HE ELECTRONIC OVEN CONTROL
Electronic
display
Oven selector
pads
(pp. 13, 15, 17)
Display/clock
•
When you first plug in the range, everything on
the display will light up for 1 to 2 seconds, then
a time of day and "PF" will appear on the
temperature display. Press the off/cancel pad to
clear "PF" from the display. If, after you set the
clock (see "Setting the clock" later in this
section), "PF" again appears on the display, your
electricity was off for a while. Reset the clock, if
needed.
•
When you are not using the oven, the display will
show the time of day.
•
When you are using the oven or minute timer,
the display will show times, temperature settings,
and what command pads have been pressed.
•
When showing the time of day, the display will
show the hour and minutes.
•
When you are using the minute timer, the display
will show minutes and seconds in the following
sequence:
– For settings from 1-59 minutes, the display will
count down each second.
– For settings 1 hour or over, the display will
count down hours and minutes.
10
HEAT BAKE BROIL LOCK'D
CUSTOM AUTO
BAKE BAKE
TEMP
BROIL CLEAN
Temperature Clock
pad pad
(pp. 13, 15, 17) (p. 11)
ON
TIMER
TIMER
SET
CLOCK LIGHT LIGHT
HR
TIMER
OFF
Minute Oven Hour
timer set light pads
and off pad (p. 11)
pads (p. 25)
(pp. 11, 12)
Using the control lock
The control lock lets you shut down the control
panel command pads. The control lock comes in
handy when you want to prevent others from
using the oven.
NOTES:
•
You can only use the control lock when the oven
is not in use or the control has not been set.
•
Set the control lock when cleaning the control
panel to prevent yourself from accidentally turn-
ing on the oven.
•
The control lock will stay on even after a power
failure.
To lock the control panel:
Press and hold the start/enter pad for 5 seconds.
You will hear a single tone and "Loc" and
"LOCK'D" will appear on the temperature
START
display.
ENTER
5 SEC
To unlock the control panel:
Press and hold START/ENTER for 5 seconds. You
will hear 3 tones followed by a single tone.
"Loc" and "LOCK'D" will disappear from
START
the temperature display.
ENTER
5 SEC
START OFF
Off/cancel
MIN
ENTER CANCEL
pad
5 SEC
(pp. 12,
14, 17)
Minute Start/enter
pads pad
(p. 11) (pp. 10, 11,
12, 14, 15, 17)