Installation Requirements; Tools And Parts; Location Requirements - Whirlpool W10203506A Installation Instructions Manual

Whirlpool 24" (61.0 cm) electric single and double built-in oven installation instructions

Hide thumbs

Table of Contents

Tools and Parts

Gather the required tools and parts before starting installation.

Read and follow the instructions provided with any tools listed

here.

Tools needed

Phillips screwdriver

Measuring tape

Hand or electric drill (for wall cabinet installations)

1" (25 mm) drill bit (for wall cabinet installations)

Level

Parts needed

UL listed or CSA approved conduit connector

UL listed wire connectors

Parts supplied

0.188 x 2.1" screws - single oven (4), double oven (6)

Check local codes. Check existing electrical supply. See

"Electrical Requirements."

It is recommended that all electrical connections be made by a

licensed, qualified electrical installer.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Cabinet opening dimensions that are shown must be used.

Given dimensions provide minimum clearance with oven.

Recessed installation area must provide complete enclosure

around the recessed portion of the oven.

Grounded electrical supply is required. See "Electrical

Requirements" section.

Electrical supply junction box should be located in the upper

right corner, 4" (10.2 cm) below the upper cut out surface of

the cabinet.

Oven support surface must be solid, level and flush with

bottom of cabinet cutout. Floor must be able to support a

single oven weight of 154 lbs (70 kg) or a double oven weight

of 287 lbs (130 kg).