Advertisement
If you have the need to reset your Point-to-Point
passphrase, you can use the following steps.
1. Click the Wireless Network icon in your
Windows taskbar.
A list of the available wireless networks in
range of your computer is displayed.
2. Choose "Open Network and Sharing Center".
3. Choose "Manage Wireless Networks" from
the left column.
4. Choose "Change adapter" menu and choose
VCI from the list.
5. Remove your stored Point-to-Point network.
The name will contain MTS6531 and the last
8 digits of Opel-Vauxhall-VCI serial number,
(MTS6531xxxxxxxx).
6. When you reconnect Opel-Vauxhall-VCI to the
computer using the USB connecting cable, a
new passphrase will be established.
5.4.3
Setting to factory default
Setting the Opel-Vauxhall-VCI to Factory Default
restores the Point-to-Point communication set-
tings to the point it had when it left the factory.
Any software upgrades that have been installed
to Opel-Vauxhall-VCI are still installed. When the
reset is finished, the VCI Manager software dis-
plays the "VCI Explorer" tab. All wireless access
point configurations will be lost.
1. Start the "VCI Manager" program.
2. Plug the Opel-Vauxhall-VCI into an external
12 V power source.
3. Plug the USB connecting cable into the
computer and Opel-Vauxhall-VCI and allow
Opel-Vauxhall-VCI to boot completely.
4. Connect to your Opel-Vauxhall-VCI in the VCI
Manager software.
5. Select the "Network Setup" tab.
6. Click <Set Factory Default>.
"
Opel-Vauxhall-VCI is set to Factory Default.
Opel Automobile GmbH
Operation | Opel-Vauxhall-VCI | 11
5.5
Connecting the diagnostic
device to a vehicle
Opel-Vauxhall-VCI Vehicle Communication Inter-
face kit contains a diagnostic connection cable
that connects Opel-Vauxhall-VCI to the vehicle's
SAE J1962 Data Link Connector (DLC).
Refer to the electrical wiring diagram for the
vehicle you are testing to determine the location
of the DLC on the vehicle.
1. Connect the 26-pin end of the diag-
nostic connection cable to the top of
Opel-Vauxhall-VCI, then tighten the screws.
2. Connect the 16-pin end of the diagnostic
connection cable to the vehicle DLC.
Powering the diagnostic device
Opel-Vauxhall-VCI is powered by the vehicle's 12
or 24-volt battery.
CAUTION – Non-approved Acces-
sories - Malfunction
Possible risk of personal injury
¶
Non-Bosch cables are not
approved for use with this equip-
ment, including a non-Bosch
USB connecting cable.
|
2019-07-01
1 689 989 451
en
Advertisement
