Advertisement
5.4
Setting up wireless communi-
cations
Opel-Vauxhall-VCI is capable of communicating
on your workshop network over Wireless. The
"Network Setup" tab in the "VCI Manager" soft-
ware provides a number of functions used to
select and configure Opel-Vauxhall-VCI network
connection interfaces, including wireless access
and security settings.
i
You must be connected to the
Opel-Vauxhall-VCI via USB to access the set-
tings on the "Network Setup" tab. If you are
not connected via USB, the controls on the
"Network Setup" tab are disabled.
i
The Opel-Vauxhall-VCI supports the Point-to-
Point method for wireless communication.
Point-to-point
With the Point-to-Point Wireless Communication
method, the Opel-Vauxhall-VCI connects to your
computer directly using a USB wireless adapter.
Each of these methods are described in the
following sections.
Opel Automobile GmbH
Operation | Opel-Vauxhall-VCI | 9
5.4.1
Activating the WLAN link via an access
point
The Opel-Vauxhall-VCI can be configured to con-
nect via an access point. The following must be
prepared before configuring:
R
An IP address and subnet mask that can be
assigned to the Opel-Vauxhall-VCI (if the
existing LAN does not assign IP addresses
automatially)
R
A wireless network access point SSID
(network name)
R
Network security standard WPA2 enabled
R
Data encryption via TKIP or WEP (64-bit or
128-bit)
R
WLAN password
The figure below shows several
Opel-Vauxhall-VCIs that are connected to a single
computer via a wirelss access point.
You use the following procedure to configure your
Opel-Vauxhall-VCI for a wirelss connection in your
network environment. Contact your IT administra-
tor before starting setup.
1. Double-click the VCI Manager icon on your
desktop to launch the "VCI Manager" soft-
ware.
2. Plug the Opel-Vauxhall-VCI into an external
12 V power source.
3. Plug the USB connecting cable into the
computer and Opel-Vauxhall-VCI and allow
Opel-Vauxhall-VCI to boot completely.
2019-07-01
en
|
1 689 989 451
Advertisement
