Automatic Standby - Tesla PrimeSound HQ-220 User Manual

Automatic standby

The speaker automatically enters standby mode if::
 no button is pushed for 10 minutes

no audible signal for 10 minutes (European Union standard ERP2)
External source of audio
The speaker can play audio from an external audio device, such as an MP3 player.
Line In (requires a 3.5mm cable)
1 Connect the 3.5 mm cable to the Line In on side of the soundbar.
2 Connect the other end of the 3.5mm cable to your mobile phone, MP3 player or other sound
source.
3 Push "1" on the remote to turn on the soundbar.
4 Push the "LINE IN" button on the remote to switch to Line In.
5 Use the controls on the connected device to start playing the sound in the soundbar.
Optical output (requires optical cable)
1 Connect the optical cable to the optical connector on the rear panel. Connect the other end of
the optical cable to the digital audio source.
2 Push "1" on the remote to turn on the soundbar.
3 Push the "OPT" button on the remote to switch to Optical output.
4 Use the controls on the connected device to start playing the sound in the soundbar.
AUX IN (requires RCA cable)
1 Connect the RCA cable to the AUX IN connector on the rear panel.
2 Connect the other end of the RCA cable to the audio source on your TV, DVD player, stereo
system, or gaming system.
3 Push "1" on the remote to turn on the soundbar.
4 Push the "AUX" button on the remote to switch to AUX In.
5 Use the controls on the connected device to start playing the sound in the soundbar.
Use the CR2025/3V battery for remote control.