Cobra RAD 480i Owner's Manual page 11

Screen Saver
Your detector has a screen saver mode. When screen saver is turned on, the screen will change
to Dark after the selected time interval (factory default is 3 minutes). While the screen is Dark,
the scanner will be displayed dimly.
NOTE: While SCREEN SAVER is activated, any alert will turn the display back on at the last
brightness setting (Bright, Dim or Dimmer). Touching any button will also turn on the display.
Smart Power
Your detector includes the Smart Power feature that, when turned On, will put the unit into
Low Power mode 15 minutes after the car's engine has been turned Off.
Before Smart Power enters Low Power mode, you will hear three beeps and Smart Power will
flash on the display. To return the unit to Normal Power mode and exit Low Power mode, start
the car, press any button or turn the unit Off and then On again.
System Info
Displays information about the versions of firmware that are installed on your detector.
Restore Defaults
To return your detector to factory default settings, press the SEN Button. Press the SEN Button
again to confirm that you want to restore factory settings.
Exit Menu
Pressing the MENU button exits the Menu.
ALERT SETTINGS
To change the Alert settings, enter the Menu by pressing the MENU button. A voice announces
"Menu" and the display will change to
Press the SEN button to enter the Alert settings menu.
Press the MARK and MENU buttons to switch between Alert settings.
Press the DIM or SEN buttons to change the selected Alert setting's value.
Alert Setting
X Band
K Band
Ka Band
Laser
VG-2
Low V. Warning
Exit Menu
11 | P a g e
Value
Off/On*
Off/On*
Off/On*
Off*/On
Off*/On
Off*/On
Press the MENU button to exit the Menu