Specifications; General Information - Hach PTM450 User Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 3
Table of contents
on page 3
on page 3

Specifications

Specifications are subject to change without notice.
Specification
Dimensions (W x H x D) 110 x 45 x 60 mm (4.33 x 1.77 x 2.36 in.)
Weight approximately
Operating temperature
Storage temperature
Relative humidity
Power requirements
1
Output
Impedance
Response time
Connections
Certifications
Warranty

General information

In no event will the manufacturer be liable for direct, indirect, special, incidental or consequential
damages resulting from any defect or omission in this manual. The manufacturer reserves the right to
make changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.
Safety information
The manufacturer is not responsible for any damages due to misapplication or misuse of this product including,
without limitation, direct, incidental and consequential damages, and disclaims such damages to the full extent
permitted under applicable law. The user is solely responsible to identify critical application risks and install
appropriate mechanisms to protect processes during a possible equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.
1
The signal output is not sensitive to daylight.
Details
250 g (0.55 lb)
15 to 35 °C (59 to 95 °F)
-5 to 40 °C (23 to 104 °F)
20 to 80%, non-condensing
Instrument input: 24 VDC 0.2 mA; External plug-in power supply: Input,
100-240 VAC, 50-60 Hz, 1.5 A, Class I; output, 24 VDC, 2.5 A
Minimum 20 mV; maximum 1250 mV
10 kOhms
3-position switch: 525 nm ±10 nm (green); 610 nm ±10 nm (red); OFF
< 1 second
Local BNC cable, 1.20 m (3.94 ft)
Safety: IEC/EN 61010-1; EMC: IEC/EN 61326-1
1 year (EU: 2 years)
N O T I C E
English 3

Advertisement

Chapters

Table of Contents
loading

Table of Contents