Base And Toe Panel - Bosch SHU43E Installation Instructions Manual

SHY66 & SHX56 Series Base and Toe Panel Installation
Installation Parts
• SHY66 & SHX56 Base Part
• Base Part Screws
• SHY66 & SHX56 Toe Panel
• SHU Toe Panel Screws
• SHY66 & SHX56 Installation Kit
(Refer to "Materials Supplied" section)
Remember to carefully check, the "Materials
Supplied" section against the Installation Kit
bag and contents.
Disassembly Steps
• Pull Toe Panel off (Figure 25).
• Loosen Screws
LOW TORQUE, USE HAND TOOL
ONLY.
• Remove Base Part by pulling it out
and downward.
After installation, water and electrical
lines are connected and the unit leveled,
assemble the base part (see below).
Assembly Steps
• Place J-Box Cover on J-Box, insert
and tighten screw (Figure 26).
• Drop screws inside holes in base part.
• Slip Base Part under and up front
bottom panel of dishwasher. Tighten
Base Part Screws - LOW TORQUE,
USE HAND TOOL ONLY.
• Slip Cotton Insulation Strip under
unit, between the bottom of Base
Part and the floor.
Junction Box Cover is required
for any installation application

BASE AND TOE PANEL

Steps
Figure 24
Figure 25
Figure 26
www.boschappliances.com
SHY66 & SHX56 BASE PARTS
ENGLISH - 15