Siemens SIMATIC STEP 7 V5.2 Getting Started page 93

Insert a new network and program a series circuit with the corresponding
addresses. Then save your program and close the block.
Programming FB10 in Statement List
STEP 7 Getting Started
A5E00171228-01
Programming a Multiple Instance
Use the respective temporary
variables. You will recognize the
temporary variables in the pull-down
menu by the symbols displayed on the
left.
Then save your program and close the
block.
The temporary variables
("PE_Setpoint_Reached" and
"DE_Setpoint_Reached") are
supplied to the output parameter
"Setpoint_Reached," which is then
processed further in OB1.
If you are programming in Statement
List, select the input area under a new
network and enter the STL instructions
shown here.
Then save your program and close the
block.
10-5