Siemens SIMATIC STEP 7 V5.2 Getting Started page 10

Introduction to STEP 7
1.3 Basic Procedure Using STEP 7
Before you create a project, you should know that STEP 7 projects can be created
Option 1
Configuring the hardware
Creating a program
If you are creating comprehensive programs with many inputs and outputs, we
recommend you configure the hardware first. The advantage of this is that STEP 7
displays the possible addresses in the Hardware Configuration Editor.
If you choose the second option, you have to determine each address yourself, depending
on your selected components and you cannot call these addresses via STEP 7.
In the hardware configuration, not only can you define addresses, but you can also change
the parameters and properties of modules. If you want to operate several CPUs, for
example, you have to match up the MPI addresses of the CPUs.
1-4
in different orders.
Designing the solution to the automation task
Creating a project (Chapter 2)
(Chapter 6)
(Chapters 3 to 5)
Transferring the program to the CPU and debugging
Since we are only using a small number of inputs and
outputs in the Getting Started manual, we will skip the
hardware configuration for now and start with the
programming.
Creating a program
(Chapters 3 to 5)
Configuring the hardware
(Chapter 6)
(Chapter 7)
Option 2
STEP 7 Getting Started
A5E00171228-01