Advertisement
RECEPTACLES
TYPE
CONFIGURATION
A
B
C
D. Circuit Protectors
The receptacles are protected by an
AC circuit protector. If the generator is
overloaded or an external short circuit
occurs, the circuit protector will trip. If this
occurs, disconnect all electrical loads and
try to determine the cause of the problem
before attempting to use the generator
again. If overloading causes the circuit
protector to trip, reduce the load.
NOTE: Continuous tripping of the
circuit protector may cause damage to
generator or equipment. The circuit
protector may be reset by pushing the
button of the protector or pulling the toggle
handle up to the "ON" position.
2
MAJOR GENERATOR FEATURES
* 25 HP Subaru OHV engine
* Cast-iron cylinder sleeve
* Low oil sensor
* Receptacles on control panel
* Electric Start
* 8 gallon plastic fuel tank
CONTROL PANEL
SCHUKO 10/16A 250VAC IP54 WITH PROTECTED
RECEPTACLES
SINGLE PHASE 230V
2P + T 32A 230VAC IP44
SINGLE PHASE 230V (1/3 OF DESIGN LOAD)
3P + N + T 32A 230/400VAC IP44
THREE PHASE 400V (FULL DESIGN LOAD)
DESCRIPTION
English
Advertisement
