Scan - HYT TC-620 Owner's Manual

21
Functions and Settings
• Monitor
Carrier condition must be satisfied for the radio to unmute
to an incoming call, regardless of CTCSS/CDCSS condition.
Press the function key to enter Monitor mode, and press
it again to exit.
Monitor Momentary
Carrier condition must be satisfied for the radio to unmute
to an incoming call, regardless of CTCSS/CDCSS condition.
Holds down the function key to enter Monitor Momentary
mode, and release it to exit.
Scan
Press the programmed Scan key to initiate scanning as-
cending through the channel numbers in scan list. Green
LED flashes during the scan process, and solidly glows
when activity is detected on a channel and signalling
condition is satisfied. Press the key again to exit scanning.
When scanning is active, the radio continuously scans
for activity on scan list members. Once activity is de-
tected on a channel, scanning pauses on the active chan-
nel for you to receive activity. Your dealer can choose
channels that you wish to scan and list them in a scan
list.
No Priority Channel
Assuming a scan list with 6 channels, if ali the channels
are non-prioritized, the normal scan operation would
check for activity in the following sequence, as figurei
hás shown.
. CH2