Panasonic Omnivision PV-D4733S Operating Instructions Manual page 25

*Important: If a remote control button does not work when pressed,
Review, Replace or Clear Program Contents:
(Recording is not in progress)
1
Press PROG
to display Program List.
2
DT START STOP CH SPD
7 9 : 00A 12 : 00A 08
8 10 : 00P 12 : 00P 02
10 8 : 00P 9 : 00P 10
SU 9 : 00P 10 : 00P L1
CANCEL : ADD / DLT
SELECT 1-8 :
ENTER : SET
EXIT : PROG
3
To Replace program...
DATE START STOP
7 SUN 9:00A 12: 00A 08
TODAY
----------------------------------------
SELE CT START DATE
SELECT :
SET : SET BACK :
END : PROG
or
To Clear program...
DT START STOP CH SPD
-- -- : -- -- : -- --
8 10 : 00P 12 : 00P 02
10 8 : 00P 9 : 00P 10
SU 9 : 00P 10 : 00P L1
CANCEL : ADD / DLT
SELECT 1-8 :
ENTER : SET
EXIT : PROG
4
Press PROG
to end the programming.
Notes
• If you are using a Cable Box, the VCR's channel for Timer Recording must be set to
the Cable Box input channel and Cable Box must be manually set to the desired
channel. Cable Box power must be left on.
• 2 minutes before Timer Recording is performed, "PLEASE PREPARE FOR TIMER
REC" appears and Timer Indicator flashes.
Be sure a cassette with record tab is loaded and DECK is in Stop mode.
• If a power interruption occurs while programming the timer, the timer program(s) may be
canceled. If "TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION"
appears on-screen, please re-enter the timer programs.
• If the start time for Timer Recording comes up during recording and playing back,
Timer Recording will not be performed.
Important notes when using DSS Receiver
• When recording programs via DSS Receiver, DSS Receiver must be left on.
• When recording programs via an antenna or cable, DSS Receiver must be turned off.
press the VCR button on the remote and try the button again.
Press
SP
to select number and
SP
SP
press SET
LP
to display.
Repeat Step 2 (p. 24)
CH
to set new programs.
SP
Press ADD/DLT.
--
SP
SP
LP
To cancel a Timer
Recording in progress...
Hold down STOP in VCR mode for
a few seconds to cancel the Timer
Recording.
(The "TIMER" Indicator goes out
on Multi Function Display.)
• Any future daily or weekly recording
will be performed as programmed.
25