Audio Output - Panasonic Omnivision PV-D4733S Operating Instructions Manual

Settings for DVD Operation (continued)

Audio Output

Select the digital output to be output from the optical
digital audio output connector of DECK.
1 Press ACTION *
to display DVD MAIN MENU.
2
DVD MAIN MENU
DISC LANGUAGES
AUDIO OUTPUT
ST I L L MODE : AUTO
TV MODE : 4 : 3 L e t t e r b o x
P A R E N T A L L O C K : L E V E L 8
SELECT :
SET : SET
END : ACTION
3
AUDIO OUTPUT
LPCM(DVD) : OFF
D o l b y D i g i t a l : B i t s t r e a m
d t s : B i t s t r e a m
DRC : OFF
SELECT :
SET : SET
END : ACTION
I I I I I "LPCM (DVD)" selections
OFF: Linear PCM of less than 48 kHz/16 bit is
output. When playing DVDs recorded in linear
PCM of over 48 kHz/20 bit, no digital audio is
output. (Factory preset)
PCM: When playing DVDs recorded in linear PCM of
48 kHz/20 bit/24 bit or more, digital audio
converted to 44.1 kHz/16 bit or 48 kHz/16 bit is
output.
(Digital output of PCM audio is restricted to
48 kHz/16 bit or below for copyright protection.)
I I I I I "Dolby Digital" selections
Bitstream: Dolby Digital bitstream (1ch-5.1ch) is
output. (Factory preset)
PCM: When you have connected a amplifier that
doesn't have a built-in Dolby Digital decoder.
I I I I I "dts" selections
Bitstream: DTS bitstream is output. (Factory preset)
PCM: When you have connected a amplifier that
doesn't have a built-in DTS decoder.
I I I I I "DRC (Dynamic Range Compression)"
selections
OFF: Normal audio range is selected. (Factory preset)
ON: For dynamic sound even at low volume, this
is useful for late-night listening. [Dolby Digital
DVDs only].
4
Press ACTION to redisplay DVD MAIN
MENU and go to step 2 to setup another
item.
Or, press ACTION twice to exit.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
48
Press
to select
"AUDIO OUTPUT,"
and
press SET
to display screen.
Press
to select an item,
and
press SET
repeatedly for
output. (See below.)
Ready Checklist
DECK is in DVD mode, press DVD.
Type of amplifier
to be connected
No amplifier is connected
AV amplifier (with digital
audio input connector)
without Dolby Digital/DTS
decoder
AV amplifier including
Dolby Digital decoder
AV amplifier including
Dolby Digital/DTS decoder
• Make settings according to amplifier
connected to optical audio output as shown
in above table.
*1 When connecting an amplifier (with an
optical digital input connector) which does
not contain the Dolby Digital or DTS
decoder, be sure to select "PCM".
If "Bitstream" is selected, starting DVD play
may cause such a high level of noise as to
be harmful to your ears and damage the
speakers.
*2 When a DTS decoder is connected, please
select "Bitstream" in "dts".
Recommended setting
LPCM Dolby
D T S
( DV D ) Digital
1
PCM*
P C M
PCM*
Bitstream
P C M P C M
Bitstream
P C M Bitstream
1
2
*