Using The Visual Fault Locator - Fluke OptiFiber Smart Remote User Manual

Using the Visual Fault Locator

The smart remote includes a visual fault locator that helps
you quickly check fiber continuity, trace fibers, and locate
faults along fibers and in connectors.
The visual fault locator port accepts connectors with
2.5 mm ferrules (SC, ST, or FC). To connect to other ferrule
sizes, use a patch cord with the appropriate connector at
one end and a SC, ST, or FC connector at the smart remote
end.
Figure 5 shows the equipment needed for using the visual
fault locator.
PASS
TEST
FAIL
TALK
TONE
LOW BATTERY
TEST
TALK
1
A
OFSR-X smart remote with multimode or singlemode
fiber module
B
AC adapter with line cord (optional)
C
One patch cord. Match fiber and connectors to be
tested; SC, ST, or FC at smart remote end. (optional)
D
Fiber cleaning supplies
Figure 5. Equipment for Using the Visual Fault Locator
Using the Visual Fault Locator
3
2
4
awl05f.eps
15