Table of Contents
Advertisement
Caring
for the filters
Do not allow grease and soil to build up
in the grease filters. It will decrease the
exhaust fan efficiency. Remove and clean
grease filters at least once a month. When
you have removed a grease filter or a
charcoal filter remember to replace the filter
before you operate the hood.
NOTE: If your microwave hood combination is
installed to recirculate air, the charcoal filter
(Part No.435941 6) should be installed. The
charcoal filter cannot be cleaned and
should be replaced every 6-l 2 months.
Electrical
Shock Hazard
Disconnect
power before removing
vent cover.
Replace all panels before operating.
Failure to do so can result in death
or electrical
shock.
Before
removing
filters:
l
For your personal safety, turn off the
electric power at the main power supply.
Grease
filters:
1. To remove grease filters, slide each filter
to the side. Pull filters downward and push
to the other side. The filter will drop out.
2. Soak grease filters in hot water and a
mild detergent. Scrub and swish to
remove embedded dirt and grease. Rinse
well and shake to dry. Do not use
ammonia,
corrosive
cleaning
agents
such as lye-based
oven cleaners,
or
place in a dishwasher.
The filter will
turn black or could be damaged.
3. To replace grease filters,
slide filter in
the frame slot on one side of the opening.
Push filter upward and push to the other
side to lock into place.
37
Advertisement
Table of Contents
