Advertisement
vibration damping units are correctly
installed and not damaged.
WARNING: Do not walk or stay below or
near a lifted product.
To safety the product to a transportation
vehicle with tie-down straps
1. Set the throttle control in the stop position.
2. Tilt the product forward until the wheels on the
handle are on the ground.
3. Attach a strap to the lifting eye and to the vehicle.
4. Attach a strap to the lift handle and to the vehicle.
Weight (uncrated, incl. oil, empty
tanks) kg/lb
Operation weight (EN500, incl. oil, ½
fuel), kg/lb
Engine brand / Type
1167 - 003 - 09.03.2020
Storage
•
•
•
•
•
•
•
•
Disposal
•
•
•
Technical data
Rammer shoe width 280 mm/11 in.
96/212
98/216
Hatz / 1B20R
Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
Clean the product before storage. Remove clay and
sand from the rammer shoe. Remove oil and dust
from the rubber parts.
Apply a thin layer of oil on the rammer shoe to
prevent corrosion.
Clean the air filter before storage.
Carefully pull the starter rope handle until there is a
small resistance.
Put a protective cover on the product.
Keep the product in a dry and frost free area.
Keep the product in a locked area to prevent access
for children or persons that are not approved.
Obey the local recycling requirements and applicable
regulations.
Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
Rammer shoe width 330 mm/13 in.
97/214
99/218
Hatz / 1B20R
13
Hide quick links:
Advertisement
