Husqvarna 333R Workshop Manual page 11

Electrical system
When no spark is obtained, dismantle
the short-circuit cable from the stop
switch.
Still no spark?
Check that the short-circuit cable is not
broken by using an Ohmmeter.
Still no spark?
Check the ignition cable's connection to
the spark plug cover.
Use pliers no. 502 50 06-01 to make a
hole in the ignition lead.
502 50 06-01
Attach the ignition coil to the ignition
cable.
When there is still no ignition spark,
dismantle the short-circuit cable from
the stop switch.
Remove the connector by prying it up
out of the throttle with a knife.
Still no spark?
Check the short-circuit cable with the
help of an Ohmmeter.
Also see "Dismantling" below.
Still no spark?
Check the spark plug connection.
Remove the spark plug cover and make
sure the ignition cable is not damaged.
Remove a segment of cable if required
to get sufficient contact at the connec-
tion coil.
When a part of the ignition lead has
been cut off it helps to use the pliers
no. 502 50 06-01 to make a hole in the
ignition lead to fit the contact coil.
NOTE!
It is important that the tip of the
contact coil hits the centre of the
ignition lead to prevent sparking.
Attach the ignition coil to the ignition
cable and ensure that the wire is folded
along the cable.
Slide the contact coil into the spark
plug cover.
TIP!
Lubricate the hole in the spark plug
cover so that it is easier to slide in the
contact coil.
2
9