Installation - DeLonghi HFX66V15C Instructions For Use Manual

of the heater and keep them away from the
sides and rear.
- Do not run cord under carpeting. Do not
cover cord with throw rugs, runners, or the
like. Arrange cord away from traffic area and
where it will not be tripped over. Do not route
cord under furniture or appliances.
- To prevent a possible fire, do not block air in-
takes or exhaust in any manner. Do not use on
soft surfaces,like a bed, where openings may
become blocked.
- A heater has hot or arcing or sparking parts
inside. Do not use it in areas where gasoline,
paint, or flammable liquids are used or stored.
- It is normal for the heater's plug and cord to
feel warm to the touch. A plug or cord which
becomes hot tothe touch or becomes distort-
ed in shape may be a result of a worn electri-
cal outlet. Worn outlets or receptacles should
be replaced prior to further use of the heater.
Plugging heater into a worn outlet / recep-
tacle/ may result in overheating of the power
cord or fire.
- If the supply cord is damage, it must be re-
placed by the manufacturer, its service agent
or similarly qualified person in order to avoid
a hazard.
- WARNING: Do not cover the appliance while
it is functioning in order to avoid overheating
which may cause risk of fire.
Please note:
This symbol indicates recommendations and important
information for the user.
- If your appliance is equipped with a poly-
thene tape used as carry handle, remove it
before connecting appliance to the outlet.
- Do not use outdoors.
- To disconnect heater, turn controls to off, then
remove plug from outlet.
- Connect to properly polarized outlets only.
- This heater is not intended for use with an
extension cord or outlet strip. Plug the cord
directly into an appropriate wall receptable.
- Check that neither the appliance nor the
power cable have been damaged in any way
during transportation.
- Do not use the appliance in rooms with a floor
area of less than 43 square feet (4mq).
- Make sure that no pieces of polystyrene or
other packaging material have been left on
the appliance. It may be necessary to pass
over the appliance with a vacuum cleaner.
- When switching on the appliance for the first
time, allow it to run at full power for at least
two hours to get rid of the unpleasant smell.
Make sure that the room in which the appli-
ance is located is well ventilated during this
operation. It is normal for the appliance to
emit small cracking sounds when you turn it
on.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
A
ON/OFF button
B
+/- Adjustment buttons
C Oscillation button
D
"ECO PLUS" function button
E
Timer button
F MODE button (for selecting the operating mode)
G
Power indicator light
H
Back cover with filter
I Receiver for remote control
USE

Installation

The appliance can be used on any horizontal surface.
Do not overload the electrical circuit. Avoid using the same
socket for other appliances.
Electrical connection
- Before plugging the appliance into the outlet, check that
the power supply corresponds to the value indicated on
the rating plate and that the power supply is adequate
for the load.
5