Adding A Dish During A Cycle; Using The Delay Wash Cycle - Whirlpool Series 980 Use And Care Manual

Adding a dish during a cycle
You can add items to the dishwasher load
anytime the Add-A-Dish
indicator is on.
1. Lift up the door latch to stop the cycle.
Wait for spraying action to stop before
opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when
restarting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
Using the delay wash cycle
Use 4 Hour Delay Start to run the dish-
washer during off-peak hours to reduce
energy usage or to reduce daytime heat
buildup in your home.
1. Close door firmly until it latches.
2. Press 4 Hour Delay Start. The pad
indicator will glow red.
3. Press a Cycle pad. The Delay Start
countdown begins when you
press the Cycle pad. If you
don't press a Cycle pad within
30 seconds, the Delay Start
indicator turns off.
4. If desired, press one or more Option pads.
The 4 Hour Delav Start indicator stays on
NOTES:
l
Press 4 Hour Delay Start anytime
during the delay period to start
dishwasher immediately.
l
Press Cancel/Drain to cancel the delay
liiiii
cycle. The 4 Hour Delay Start
indicator will turn off. Press new
Cycle and Option pads.
I.-
. You can add items to the load anytime
during the delay countdown. After adding
items, close the door firmly until it latches.
The delay countdown will not continue if
the door is not latched.
16