Adding Items During A Cycle; Using Delay Hours - Whirlpool Inglis 586 Series Use & Care Manual

SETTING THE CONTROLS

Adding items during a cycle

You can add an additional item to the dish-
washer anytime before the main wash portion
of a cycle. See the "Selecting a wash cycle"
chart.
1. Lift up the door latch to stop the cycle. Wait
for spraying action to stop before opening
the door.
2. Open the door and add the item.

Using Delay Hours

Use a delayed start to run the dishwasher
during off-peak hours to reduce energy
usage or to reduce daytime heat buildup in
your home.
1. Close door firmly until it latches.
2. Press Delay Hours once for a
2-hour delay start, twice for 4
hours, or three times for 6
4
2 6
hours. The indicator will glow.
DELAY
HOURS
3. Press a Cycle pad. The Delay Start
countdown begins when
you press the Cycle. If you
don't press a Cycle within
30 seconds, the Delay Hours
indicator turns off.
18
3. Close the door, but do not latch it. Wait
30 seconds for the air in the dishwasher
to warm up. Doing so reduces the
amount of moisture in the vent when re-
starting a cycle.
4. Close the door firmly until it latches. The
dishwasher resumes the cycle.
4. If desired, press one or more Options.
The Delay Hours indicator
4
2 6 stays on until the wash cycle
begins.
DELAY
HOURS
To cancel delay and start the
dishwasher:
1. Press Delay Hours until the 6 glows.
2. Press Delay Hours one
2 4 6
more time. The delayed cycle
starts.
DELAY
HOURS
To cancel delay and cycle:
1. Press Cancel/Drain. The Delay Hours
indicator turns off.
2. Press new Cycle and
CANCEL
Options.
DRAIN
NOTE: You can add items to the load
anytime during the delay countdown. After
adding items, close the door firmly until it
latches. The delay countdown will not
continue if the door is not latched.