Table of Contents
Advertisement
When cycle
is finished
1. Turn hot water off. (This can be done after the
last rinse.)
2. Press the red button on the connector to
release the water pressure
3. Lift slightly on the hose connector while pulling
down the locking collar. Pull down on the
connector
Locking
collar
4. Empty any remaining water from the
connector by turning the connector
upsidedown.
5. Unplug power supply cord and return to
storage compartment.
6. Return hoses to storage compartment.
Hose connection
Electrical
connection
A power supply of 120 volts, 50160 Hz AC, 15 or
Sprang
20 amps, is required. For your personal safety,
grounding
this appliance must be grounded. This appliance
PQI
is equipped with a power supply cord having a
3-prong grounding plug. To minimize possible
shock hazard it must be plugged into a mating
1
3-prong grounding type wall receptacle,
grounded in accordance
with the National
Electrical Code and local codes and ordinances.
e
If a mating wall receptacle is not available, it is
Power supply
the responsibility
and obligation of the customer
to have a properly grounded 3-prong wall
receptacle installed by a qualified electrician.
Personal
Injury Hazard
An extension cord should not be used
with this appliance.
Such use may result in a fire, electrical
shock or other personal injury.
Do not, under any circumstances,
remove the power supply
cord ground
prong.
Converting
to built-in
Your Whirlpool Portable Dishwasher
can be converted to a built-in (undercounter)
model by
using conversion
kit No. 4317856. The kit is available at your Whirlpool dealer or authorized
Whirlpool@ service company. Instructions
are included with the kit.
19
Advertisement
Table of Contents
