Whirlpool GDP8500 Use & Care Manual page 18

Connecting A Portable
Dishwasher
NOTE: A special adapter must be installed on the
faucet before the dishwasher can be connected.
Complete instructions and the adapter are
packed with your dishwasher.
When moving your dishwasher make sure the
door is latched. Hold the dishwasher at the top
front comers.
Before starting
1. Run water at faucet until it is hot. Turn water
Off.
2. Pull hoses out of their storage compartment on
the back of the dishwasher.
NOTE: Make sure the hoses are not
kinked or twisted. Kinked hoses reduce
washing performance.
3. Pull down on the locking collar while lifting the
hose connector onto the faucet adapter.
4. When the connector snaps into place release
the locking collar.
5. Turn the hot water on slowly until it is all the
way on.
6. Plug in power supply cord.
7. See page 6 for instructions on how to
start the dishwasher
Locking collar
/
UJ
\
Hose corm l&ion
While dishwasher is
running
You can draw water from the faucet while the
l
Press the red button on the hose con-
dishwasher is connected. Do not draw water
nectar to draw water from faucet. (The
while the dishwasher is filling or while water is
faucet is set on hot. Adjust faucet for the
being pumped out. (This helps prevent a low fill
water temperature you want.)
when dishwasher is filling or mbing drain water
with fresh water.)
NOTE: Turn hot water back on after you
draw water
from
faucet. Turn off cold
water.
18