Whirlpool DU9200XT Series Use & Care Manual page 10

HEAT DRY
HI-TEMP
The AIR DRY signal light
will be OFF when HEAT = - '.
DRY is selected. Heat Dry
means the air in the dish-
washer is heated during
m
When HI-TEMP is selected,
the water for the main
wash and final rinse is
heated to 145°F (63°C).
While the water is heat-
the "dry" portion of any cycle - except RINSE
& HOLD.
ing, the WATER HEATING signal light will be ON.
POTS & PANS has the HI-TEMP option preset. HI-
TEMP cannot be selected with RINSE & HOLD.
AIR DRY
The AIR DRY signal light
will be ON when AIR DRY
is selected. The AIR DRY
Option helps save en-
erqv, but the dishes take
NOTE: The WATER HEATING signal light
flash at the end of the cycle if the water
not heat to 145°F (63°C). (See page 17).
longer to dry (overnight)and some water spot-
ting may result. Some items (such as plastics]
may need towel drying. For best results, use a
liquid rinse aid such as Jet-Dry" in the rinse aid
dispenser.
will
did
DELAY Pad
. -
Press the DELAY pad once to display the last
'The DELAY Pad
mm.
cycle and options selection.
allows you to
Quickly press the pad again to select a 2
B 1
hour delay. The 2 HOURS signal light will come
delay the start of
on.
a cycle for 2
hours after load-
ing the dishwasher. For example, use DELAY to
run the dishwasher during off-peak hours of
electrical use.
1.
2.
immediately.
3. Pressing the DELAY Pad repeatedly will select
l
Press the CANCEL pad to cancel the delay
(in order] no delay, then 2 hours, etc. If no de-
and clear the delay signal light.
l
You may add items to the load at any time
lay is selected, all delay signal lights will be
during the delay. Close the door firmly to
Off.
latch it.
4. After 2 hours, the signal light will turn off and
the dishwasher will start.
l
You may press START at any time during the
delay if you want the dishwasher to start .__._. .- - -
CANCEL Pad
The CANCEL pad allows
you to cancel a cycle, to
clear the signal lights or
to make a new selection.
If the dishwasher is wash-
ing, itwill go into a 2 minute drain automatically
before shutting off. Pressing CANCEL again stops
the drain. If the dishwasher had not been started
or is not washing, it will clear the display. Press-
ing CANCEL again will start a 2 minute drain, if
needed.
10