Pioneer SX-319V-K Service Manual page 10

1
A SETUP
Press to access the System Setup menu.
RETURN
Confirm and exit the current menu screen.
Press BD orDVR first to access:
TOP MENU
Displays the disc 'top' menu of a BD/DVD.
HOME MENU
Displays the HOME MENU screen.
RETURN
Confirm and exit the current menu screen.
B
MENU
Displays the TOOLS menu of Blu-ray Disc
player.
Press TUNER first to access:
T.EDIT
Memorizes/names stations forrecall.
BAND
Switches between AM, FM ST (stereo) and
FM MONO radio bands(page34).
ijkl ( TUNE i/j , PRESET k/l ),
9
C
ENTER
Use the arrow buttons when setting up your
surround sound system. Also used
to control BD/DVD menus/options.
Use the TUNE i/j buttons can be used to
find radio frequencies and the
PRESET k/l buttons can be used to select
preset radio stations.
10 Component control buttons
The main buttons (
control a component after you have selected it
using the input source buttons.
The controls above these buttons can be
D
accessed after you have have selected the
corresponding input source button (for
exampleBD,DVR orTV). These buttons also
function as described below.
PressRECEIVER first to access:
BASS –/+
Use to adjust Bass
TRE –/+
Use to adjust Treble
PressTV first to access:
ANT
Use to select the VHF/UHF antennas or
Cable TV.
E
11 Number buttons and other component
controls
Use the number buttons to directly select the
tracks on a CD, DVD, etc. There are other
buttons that can be accessed after the
RECEIVER button is pressed. (For example
TEST TONE, etc.)
HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCRrecorders.
F
Note
1The tone controls are disabled when the listening mode is set to DIRECT or PURE DIRECT.
10
1
2
, , etc.) are used to
d e
1
1
SX-319V-K
2
3
TEST TONE
Outputs the test tones on each channel.
Use the i/j buttons to select the channe
and use the k/l buttons to adjust the
level on each channel. PressingTEST
TONE again exits the test tone mode.
CH SELECT
Press repeatedly to select a channel, then
use+/– to adjust the level.
CH SELECT +/–
Use to adjust the channel levels.
SPEAKERS
Use to change the speaker system on or o
SLEEP
Press to change the amount of time
beforethe receiver switches into standby
(30 min – 60min – 90 min – Off). You ca
check the remaining sleep time at any tim
by pressing SLEEP once.
DIMMER
Dims or brightens the display. The
brightness can be controlled in four steps.
12 u SOURCE
Turns on or off the power of the Pioneer DVD/
DVR units when BD orDVR is selected using
the MULTI CONTROL buttons.
13 TV CONTROL buttons
These buttons can control only be used with
Pioneer flat panel TVs.
u
Use to turn on/off the power of the TV.
INPUT
Use to select the TV input signal.
CH +/–
Use to select channels.
VOL +/–
Use to adjust the volume on your TV.
14 MASTER VOLUME +/–
Use to set the listening volume.
15 MUTE
Mutes/unmutes the sound.
16 DISPLAY
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.
17 SHIFT
Press to access the 'boxed' commands (abov
the buttons) on the remote. These buttons are
marked with an asterisk (* ) in this section. Th
button is also used for operating ZONE 2.
3
4
4