Technical Specifications - Paradyne Hotwire 8775 Installation Instructions Manual

Technical Specifications

Planning the 8775 Termination Unit Installation
2
Specifications
Size
Weight
Approvals
Safety Certifications
Power
Cables and Cable Guide
Physical Environment
Operating temperature
Storage temperature
Relative humidity
Shock and vibration
* Technical specifications are subject to change without notice.
Review the following list to help plan for the installation.
Obtain the applicable cables; refer to Cables You Need .
Make sure the Hotwire DSLAM chassis is installed and power is supplied to
the chassis.
After the 8775 Termination Unit is installed, there are configuration
procedures that must be performed before you can begin to use the 8775
Termination Unit. Refer to the Hotwire 8775 MSDSL Termination Unit User's
Guide , for more detailed configuration procedures.
March 1998
Criteria*
Length 10 inches (25.4 cm)
Height 12.3 inches (31.1 cm)
Width 0.8 inch (2.0 cm)
Approximately 1.3 lbs. (0.6 kg)
Refer to the equipment's label for approvals on product.
The 8775 Termination Unit contains a DC-to-DC
converter that requires – 48V power input. The – 48V
power is distributed through the Hotwire DSLAM
backplane.
Maximum Power Dissipation = 19 watts
Part Number Description
8700-F1-500 Cable Guide for 8800 DSLAM
8700-F1-501 V.35: 100-Pin Plug to
Four MS34 Receptacles
8700-F1-502 X.21: 100-Pin Plug to
Four DB15 Receptacles
8700-F1-503 RS449: 100-Pin Plug to
Four DB37 Receptacles
8700-F1-504 EIA-530A: 100-Pin Plug to
Four DB25 Receptacles
32 to 122 F (0 to 50 C)
– 4 F (–20 C) to 158 F (70 C)
5% to 85% (noncondensing)
Withstands normal shipping and handling.
8775-A2-GZ40-00