Using Your Cooktop; Using The Surface Burners - Whirlpool SC8430ER Use & Care Manual

Using your cooktop
Using the Surface Burners
This cooktop is equipped with either
standing pilots or electronic ignitors.
Standing pilots must be lit initially
with a match following the directions
RIGHT REAR
CONTROL KNOB
on page 6. The pilot light will remain
lit when the burners are turned off. To
turn a burner on again, just push in
and turn the control knob to LIGHT
and the burner will light. Electronic
ignitors automatically light the
burners each time they are used.
LEFT REAR
CONTROL KNOB
I
Control knobs must be pushed in,
then turned to the LIGHT position. On
electronic ignitor model, the clicking
sound is the ignitor sparking.
After the burner lights, turn the control
RIGHT FRONT
knob back to a desired setting. The
CONTROL KNOB
control knob can be set anywhere
between HI and low setting.
Do not
cook wlth the control In the LIGHT
posltton.
Prolonged Power Failure
Surface burners with electronic igni-
tors can be manually lighted. Hold a
lit match near a burner and turn the
control to the LtGHT position. After the
burner lights, turn the control to the