GE 4PE350A3 Instructions Manual page 18

EBI-6351
COLOR CAMERA
MECHANICAL
Length:
9.00 inches
Width:
5.25 inches
Height:
1.00 inch
Timing and Calibration Generator
Board, PL -7674517
ELECTRICAL
1. Power Inputs
+20 volts d -c.
-20 volts d -c.
28 volts a -c.
2. Signal Inputs
Camera Sine Wave:
15 -kHz sine wave, approximately 20
volts peak -to -peak.
Horizontal Blanking:
Approximately
4.0 volts
peak -to -
peak.
Auxiliary Video:
Noncomposite,
approximately
0.7
volt peak -to -peak.
3. Signal Outputs
Calibration Signal:
15 -kHz sawtooth, adjustable from
0.4 to 1.0 volt peak -to -peak.
To High -Voltage Power Supply:
15 -kHz sine wave, approximately 20
volts peak -to -peak.
To Camera Sweep:
15 -kHz, approximately 20 volts peak -
to -peak.
To Viewfinder Sweep:
15 -kHz sine wave, phaseable over
range of 5 microseconds.
4
Squash Pulse:
15 -kHz pulse, 4.0 volts ± 0.5 peak -
to -peak, 7 microseconds wide, negative go-
ing.
Camera Power Supply Trigger:
15 -kHz pulses, -15 to -20 volts peak -
to -peak, approximately
one microsecond
wide, negative going.
Tally Light Supply:
20 volts.
MECHANICAL
Length: 9.25 inches
Width:
2.50 inches
Height: 1.25 inches
Camera Sweep Board, PL -7674641
ELECTRICAL
1. Power Inputs
+100 volts d -c.
+20 volts d -c.
-20 volts d -c.
-6 volts d -c.
-1.5 volts d -c.
2. Signal Inputs
Vertical Drive:
4.0 volts ± 0.5 peak -to -peak.
Horizontal Sine Wave:
At least 20 volts peak -to -peak.
3. Signal Outputs
Vertical Sweep:
Sweep HEIGHT control set fully CW
(clockwise), 3.0 volts peak -to -peak.
a
Sweep HEIGHT control setfully CCW
(counterclockwise) 5.0 volts peak -to -peak.