LG 32LY760H Owner's Manual page 32

32
EXTERNAL CONTROL DEVICE SETUP
18. Energy Saving (Command: j q)
To reduce the power consumption of the TV.
Transmission [j][q][ ][Set ID][ ][Data][Cr]
Data 00 : Off
Data 02 : Medium
Data 04 : Auto / Intelligent sensor
* (Depending on model)
Data 05 : Screen off
Acknowledgement [q][ ][Set ID][ ][OK/NG][Data]
[x]
19. Auto Configuration (Command: j u)
To adjust picture position and minimize image
shaking automatically. Auto configuration only
works in RGB-PC mode.
Transmission [ j ][u][ ][Set ID][ ][Data][Cr]
Data 01: To set
Acknowledgement [u][ ][Set ID][ ][OK/NG][Data]
[x]
20. Channel Tuning (Command: m a)
To tune channel to following physical/major/
minor number.
Transmission [m][a][ ][Set ID][ ][Data00][ ]
[Data01]
[ ][Data02][ ][Data03][ ][Data04][ ][Data05][Cr]
Digital channels have a Physical, Major, and
Minor channel number. The Physical number is
the actual digital channel number, the Major is
the number that the channel should be mapped
to, and the Minor is the sub-channel. Since the
DTV tuner automatically maps the channel to
the Major number, the Physical number is not
required when sending a command.
Data 00: Physical Channel Number
ATV air: 02~45, ATV cable: 01, 0E~7D
DTV air: 01~45, DTV cable: 01~87
Data 01 & 02: Major Channel Number
Data 01: High byte Data 02: Low byte
Two bytes are available for the Major and
Minor, normally only the second byte is used.
Data 03 & 04: Minor Channel Number
Not needed for ATV.
The table above lists the binary code which
must be converted to Hexadecimal before
sending. For example:
The binary code to tune the sub source to
Data 01 : Minimum
Data 03 : Maximum
an ATV cable channel is 1000 0001, which
translates to 81 in Hex.
Data 05: Attribute
* 7th bit : For which source do you want to
change the channel.
* 6th bit: Use a two part or one part channel.
Most cases just use 0 since it's ignored when
using ATV.
* 5th bit: Use 0 with ATV since it can only use
the physical channel number. Normally use
1 for DTV since most times it doesn't matter
what the physical number is.
* 4th bit: Set to 0.
* 3-0 bits: Choose signal type.
* Tune Command Examples:
1. Tune to the analog (ATV) cable channel 35.
Data 00 = Physical of 35 = 23
Data 01 & 02 = No Major = 00 00
Data 03 & 04 = No Minor = 00 00
Data 05 = 0000 0001 in binary = 01
Total = ma 00 23 00 00 00 00 01
2. Tune to the digital (DTV) local channel 30-3.
Data 00 = Don't know Physical = 00
Data 01 & 02 = Major is 30 = 00 1E
Data 03 & 04 = Minor is 3 = 00 03
Data 05 = 0010 0010 in binary = 22
Total = ma 00 00 00 1E 00 03 22
* Use the feature depending upon your model.