Adcom GTP-760 Owner's Manual page 17

23 S-Video Inputs and Outputs
Note: This section assumes that you've elected to use S-Video sources and display devices and that
you've set the GTP-760 for S-Video signal transfer by following the steps described in the boxed note
entitled Composite or S-Video? on page 9.
When hooking up S-Video capable audio/video components, follow the steps outlined in Sections 19
and 22 above. However, ignore the instructions for composite video connections and substitute
the following:
DVD in: Connect the DVD player's S-Video output to the mini-DIN connector under the S-Video
"DVD in" label.
Digital 2 in: Connect the source's S-Video output to the mini-DIN connector under the S-Video
"dig. aux in" label.
Digital 1 in (Dolby Digital RF optional): Connect the source's S-Video output to the mini-DIN
connector under the S-Video "digital 1 in" label.
LD in: Connect the LD player's S-Video output to the mini-DIN connector under the S-Video
VCR in: Connect the VCR's S-Video output to the mini-DIN connector under the S-Video
"VCR in" label.
VCR out: Connect the VCR's S-Video input to the mini-DIN connector under the S-Video
"VCR out" label.
Video aux in: Connect the source's S-Video output to the mini-DIN connector under the S-Video
"video aux in" label.
Room 2 Output: Connect the video display device to the S-Video mini-DIN output under the
S-Video Monitor Outputs: Connect the main monitor or display device to the mini-DIN jack
Video Processor Input and Output: Connect the Video Processor's S-Video output to the mini-DIN
"LD in" label.
"room 2 out" label.
under the "S-Video monitor 1" label. You may use the "S-Video monitor 2" jack for
another monitor if desired. Properly connected, either monitor will then display an
image from a video source or on-screen menu information when appropriate.
jack immediately under the "video processor in" label. Then connect the video
processor's S-Video input to the mini-DIN jack under the "video processor out" label.
16