Before The First Start-Up; Operation - Intex ANSG uClean 14 Series Operating Manual

en

2 Before the first start-up

Assembly
See Fig. B.
1. When unpacking, make sure everything is complete.
2. Immediately report any transport damage to the retailer.

3 Operation

Before every use, please note
Make sure that the following conditions are met:
r Vacuum cleaner, mains connection cable and suction hose are not damaged.
r All filters have been inserted and are not damaged.
Operating modes
Operating mode (depending on equipment)
Off
On
Minimum suction power
Maximum suction power
Standby mode for automatic switch-on,
infinitely adjustable speed control ECO-MAX
Standby mode for automatic switch-on,
infinitely adjustable speed control ECO-MAX,
automatic filter cleaning
Suck up dry materials
Tools required
Main filter (filter cartridge)
Filter bag for dust-free disposal of fine-grained
material to be sucked up
Accessories depending on the area of
application
1. Set required operating mode on the switch.
9 Vacuum cleaner is ready for vacuuming.
2. To adjust the suction power, select from the following options (depending on equipment):
– Move switch to ECO position
– Set speed on the switch
6
Description Switch position
Wall socket under voltage 0
Wall socket under voltage, manual I
operation
Vacuum cleaner operates at low power ECO
Vacuum cleaner operates at maximum MAX
power
Vacuum cleaner is switched on and off A
by the electrical tool
If the suction power drops, the filter
is cleaned in breaks between work (=
switched off electrical tool)
Notes
Vacuum cleaner, filter and accessories need to be dry.
If frequently changing between wet and dry vacuuming, use
a separate main filter.
When vacuuming soot, cement, plaster, flour or similar
dusts: Insert a filter bag in the dirt container so that the
dust does not stick and or cake.
– Set auxiliary air slide on the handle tube
Suck up liquids
Volume of liquid
Small volume of liquid
Large volume of liquid
1. Remove filter bag from the dirt container before sucking up liquids.
2. Slightly open auxiliary air slide on the handle.
3. Move switch to position I.
Before switching off the vacuum cleaner:
1. Remove suction nozzle from the liquid.
9 Residual water in the suction hose is sucked into the container and cannot leak out.
If the floating valve disrupts the suction process when the container is full:
1. Switch vacuum cleaner off.
2. Empty dirt container and filter cartridge.
Connect an electrical tool
See Fig. C.
Use socket on vacuum cleaners with automatic switch on/off (switch position A) to connect electrical tools. The
vacuum cleaner is switched on and off by the electrical tool. In switch position 0, the socket can be used as an
extension cable, e.g. for a light.
Connection value: Vacuum cleaner + electrical tool = max. 16 A (value depends on the country version, pay
attention to technical data).
WARNING!
The socket on the vacuum cleaner is always live.
Risk of injury due to electrical tool automatically starting up.
1. Before plugging in: Switch off electrical tool.
Blowing function
See Fig. E.
Only use the blowing function for cleaning, removing dust from and drying machines and appliances.
After work
See Fig. F.
1. Roll up mains connection cable and suction hose.
2. Store the accessories in the accessories holder.
Tools required
Main filter (filter cartridge)
Water nozzle
Main filter (foam)
Water nozzle
en
7