Setting(Others): Test Pattern - Mitsubishi Electric KD Series User Manual

5-2 Setting(others): Test Pattern

Address Register name
6020h TestImageSelector
6024h TestLineRate
602Ch TestTriggerMode
5-2-22 Test pattern
[Function]
Output a test pattern over Camera Link® in order to make
sure image data communication from CIS to frame grabber.
Please use this function when you setup your system.
1) Grey ramp horizontal
2) Grey ramp vertical
TM-XJ959A
R/W Parameter
Data
Set test pattern
R/W 0 to 3 0:OFF /1:Grey ramp horizontal
2:Grey ramp vertical
‫( = ]ݖܪ[݁ ݐܴܽ ݁݊ ݅ܮ‬register value)
Set line rate for test pattern
R/W 0 to 55000
Set source of sync signal
R/W 0 or 1 0:Internal sync mode (output test pattern based on
TestLineRate), 1: External sync mode
Function
/3:RGBW
3) RGBW
[Remark]
1) When you use this function based on Internal sync
mode, you need to set line rate with "TestLineRate".
2) The purpose of this function is to make sure if the data
transfer is appropriated operated. When you use this
function, the image data is not output.
3) After using Test pattern function, please turn off & turn
on CIS prior to operate CIS to take the image.
(If without turn off CIS, incorrect picture is output from
CIS.)
Camera Link® is a trade mark registered by AIA（Automated Imaging Association).
Initial
0
55000
0
87
© Mitsubishi Electric Corporation