Operation - Ryobi RG-2100I Owner's Operating Manual

Before using this generator it must be prepared
correctly before use. Locate the generator on firm
level ground away from buildings or other
structures ensuring that the exhaust is not
obstructed.
Your generator must be properly connected to an
appropriate ground to help prevent electric shock.
WARNING. Failure to properly ground
the generator can result in electric shock.
A earth point connected to the frame of the
generator has been provided on the power panel,
Fig.6. For remote grounding, connect of a length of
heavy gauge (12 AWG minimum) copper wire
between the generator ground terminal and a cop-
per rod driven into the ground.
STARTING THE GENERATOR
CAUTION. Always check the oil level
before starting the engine (see Page 8).
Never start your generator without a
"earth" stake attached or with electrical appliances
or power leads attached.
1. Turn the fuel cap vent to the ON position (Fig.5)
Note: If the fuel cap vent is not ON the
generator will not operate correctly.
2. Turn the Fuel tap valve and engine switch to
the CHOKE position, Fig.7.
Fig. 7
3. Hold down the generator firmly with one hand
on the handle. With the other hand grip the
recoil starter handle (Fig.8) and pull and
return the rope gently 3-4 times to let the
engine breath in the fuel mixture from the
carburetor. Pull the cord sharply. Continue this
procedure until the engine starts.
GENERATOR 'EARTHING'
We strongly recommend that you consult with a
qualified electrician to ensure compliance with local
electrical codes.

OPERATION

4. When the engine has been successfully started
and is running smoothly turn the Fuel tap valve
and engine switch to the ON position (Fig.9).
10
Earth Point
Fig. 6
Fig. 8
CAUTION. Avoid damaging the plastic
case of the crankshaft while pulling the
rope. Aways return the recoil starter cord
handle slowly.
Fig. 9