iDect Solo Single User Manual page 48

Intercom and transfer Intercom and transfer
Intercom and transfer Intercom and transfer
"I can't transfer a call" "I can't transfer a call" "I can't transfer a call" "I can't transfer a call"
Make sure that the other handset is in range of the base unit.
Make sure that you have entered the correct number for the other
handset.
Batteries Batteries
Batteries Batteries
"The handset's battery cells are running low within an hour or two" "The handset's battery cells are running low wit "The handset's battery cells are running low wit "The handset's battery cells are running low wit
Before you first use the handset, you must leave it to charge on the
base unit or charging pod for at least 15 hours.
You may need to replace the batteries.
Check the connection between the base unit and the mains power
socket.
"I try t "I try to recharge the batteries but I still get a warning that they are low" o recharge the batteries but I still get a warning that they are low"
"I try t "I try t o recharge the batteries but I still get a warning that they are low" o recharge the batteries but I still get a warning that they are low"
You need to replace the batteries. Dispose of used batteries safely –
do not burn, immerse them in water, disassemble, or puncture the
batteries.
Do not use non-rechargeable batteries in your handset – they may
explode, causing damage.
Registration Registration Registration Registration
"I am not able "I am not able "I am not able to to to to register another handset" "I am not able
The maximum number of 4 handsets has been reached. You will need
to unregister a handset in order to register a new one.
If the fault persists... If the fault persists...
If the fault persists... If the fault persists...
Disconnect all other instruments connected to the same line and try to
make a call.
Disconnect the base unit from the telephone line and plug a different
phone into the master telephone socket. Try making a call. If this
works, the line is OK.
If the call does not work, and you are using a two-way socket adapter,
remove it and plug a telephone directly into the socket.
If the call now works, the adapter may be faulty.
If you cannot make a call, the fault may be on the exchange line.
Contact the service provider.
This manual downloaded from http://www.manualowl.com
register another handset" register another handset" register another handset"
hin an hour or two" hin an hour or two" hin an hour or two"
46