Philips Sonicare FlexCare+ User Manual page 26

ENGLISH
Preparing for use
Attaching the brush head
1 Align the brush head so the bristles face the front of the
handle. (Fig. 1)
2 Firmly press the brush head down on the metal shaft until it stops.
Charging your Sonicare
1 Put the mains plug of the charger in the wall socket.
2 Place the handle on the charger (Fig. 2).
The flashing light of the battery gauge indicates that the toothbrush
,
is charging.
- 1 solid green LED indicates that the toothbrush is 34-66% charged.
- 2 solid green LEDs indicate that the toothbrush is 67-94% charged.
- 3 solid green LEDs indicate that the toothbrush is fully charged.
Note: If the battery charge of your Sonicare is low, you hear 3 beeps and 1
LED of the recharge gauge flashes yellow for 30 seconds after completing
the brushing cycle.
Note: To keep the battery fully charged at all times, you may keep your
Sonicare on the charger when not in use. Once the Sonicare is fully charged,
the charger draws minimal energy from the wall socket.
Note: It takes at least 24 hours to fully charge the battery.
Using the Sonicare
Brushing instructions
1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
towards the gumline (Fig. 3).
3 Press the power on/off button to switch on the Sonicare.
4 Apply light pressure to maximise Sonicare's effectiveness and let
the Sonicare toothbrush do the brushing for you. Do not scrub.
FlexCare+_EN_A6_cs6.indd 25
25
16/05/13 10:4