Stihl BT 130 Instruction Manual page 14

English
5
4
Set the choke knob (4) to:
N
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
Press the manual fuel pump
N
bulb (5) at least five times.
12
Cranking
Place the unit on the ground so that
N
it is secure.
Put your left foot on the handle
N
frame.
Left hand on the handle frame.
N
Pull the starter grip slowly with your
N
right hand until you feel it engage
and then give it a brisk strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
Do not let the starter grip snap back.
N
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
Continue cranking.
N
When engine begins to fire
Set the choke knob to e and
N
continue cranking until the engine
N
runs.
As soon as the engine runs
Blip the throttle trigger (2) – the slide
N
control (3) moves to the run
position F and the engine settles
down to idling speed.
NOTICE
Since the auger brake is still engaged,
the engine must be returned to idling
speed immediately – or the clutch might
otherwise be damaged.
BT 130