Tanita BC-1000 Manual

Using TANITA Wireless Remote Tabletop Display
Initial Setting
Please make sure the scale is within 17feet (5m) with batteries inserted.
Insert batteries into the remote display.
Press any front panel button to start the communication process.
The wireless icon ( ) on the display will blink while the remote display communicates
with the platform. After the communication is successfully done (wireless icon
disappears), continue to step 1 "Set Hour".
Note: If the communication fails, the display will show "ErrC", press any front panel
button to restart the communication process.
1. Set Hour
Press s/t to set hour and then press SET.
The unit will beep once to confirm.
2. Set Minute
Press s/t to set minute and then press SET.
The unit will beep twice to confirm the programming.
Resetting time
•
Press the clock button on the bottom of the remote display.
Then follow the procedure 1 and 2.
Setting and storing personal data in memory
You will receive readings only if data has been programmed into the Tanita Remote Tabletop Display.
1. S elect Personal Data Number
Use the SET button to activate the unit. Use s/t buttons to select a personal data number. Press SET.
2. S et Age
Use s/t buttons to select age. Press SET.
3. S elect Female or Male
Use s/t buttons to select Female ( ) / Male ( ) / Athlete Female ( / ) / Athlete Male ( / ). Press SET.
4. S pecify Height
Use s/t buttons to select height. Press SET.
5. Select Activity Level (Except D-1100)
Use the s/t buttons to specify Activity Level. Press the SET button to confirm
The remote display will beep twice and the display will flash all data three times to confirm the programming.
The power will then shut down automatically.
To use the DCI (Daily Calorie Intake) feature properly, you need to set the Activity Level.
Level 1 = Inactive lifestyles (little or no exercise)
Level 2 = Moderately active lifestyles (occasional, low intensity exercise)
Level 3 = Adult involved in intense physical activity
Note: If you select the Athlete Mode, it will automatically set the Activity Level to Level 3.
Switching The Weight Mode
Select your preferred weight mode using the weight mode switch on the bottom of the Remote Display.

Battery Cover
Backlight Button
Upright Position