Table of Contents
Advertisement
OPERATING INSTRUCTIONS
USING THE VERTICAL STEAM FUNCTION
5. Move the Temperature Control and Variable Steam to desired
setting.
6. Allow approximately 45 seconds for the iron to reach the desired
temperature. The red Power On/Heating Light will turn off.
7. Hold the iron 7-15 inches away from the garment and press the
burst of steam button once.
8. Wait a few seconds before pressing the Burst of Steam Button
again. The red Power On/Heating Light will cycle on and then off
during this process. Do not press the burst of steam button more
than three times successively when the red Power On/Heating Light
is ON. For best results, keep Water Tank at least half full.
9. When finished, move Temperature Control to the OFF position and
Variable Steam to no steam position and unplug the iron. Allow
iron to cool before cleaning the exterior of the iron for storing.
CAUTION: AVOID COMING IN CONTACT WITH ESCAPING STEAM.
EMPTYING THE WATER TANK
The Water Tank should be emptied after each use.
1. When finished, move Temperature Control to the OFF position and
turn the Variable Steam to no steam position and unplug the iron
from the electrical outlet.
2. Hold the Iron upside down and gently shake it to remove the
remaining water in the tank.
3. Press the Burst of Steam and Spray Buttons to release any
remaining water.
FLUSHING
Flushing the iron is advised after every 5 uses or more regularly to
prevent harmful mineral build-up that can clog the iron and prevent it
from heating and steaming properly.
1. Fill the Water Tank half full; see FILLING THE WATER TANK.
2. Stand the iron on its heel in an upright position on an iron-safe,
heat resistant surface. Plug into a 120 V ~ 60 Hz outlet.
3. Move the Temperature Control to the maximum setting.
(Cont.)
11
(Cont.)
Advertisement
Table of Contents
