Before Using For The First Time; Operating Instructions - Westinghouse WST6003 Instructions Manual

BEFORE USING FOR THE FIRST TIME

Your WST6003 Flat Fan Heater is designed for space heating or as a
supplementary heat source. It is not intended to be the main source of heat.
NOTE: Make sure the Heater Dial is in the
1. Place your Heater on a level, stable surface. It is recommended that the
Heater be placed on the floor, where it can keep the lower level of the
room warm. Be sure the sides and back of the Heater are at least 3 feet
away from any combustible materials. DO NOT COVER the Air Intake or
the Front Safety Grill.
2. Plug the Flat Fan Heater into a 120V AC electrical outlet.
3. There are 3 settings on the Heater Dial:
Fan / Breeze Fan only

OPERATING INSTRUCTIONS

Setting the Thermostat for Heat
1. When heating a cold area in the room, first turn the Thermostat Dial to
the MAX position.
2. Next, turn the Heater Dial to either LO or
3. The amber Power ON/OFF Light will illuminate when you turn the
Heater Dial from the OFF position. The Fan will begin to rotate.
Your Heater will quietly and efficiently heat your area.
4. When the desired temperature is reached, turn the Thermostat Dial
counter-clockwise to a lower setting until the Fan turns itself OFF.
5. The temperature is now pre-set.
6. When you are finished using the Flat Fan Heater, turn the Heater/Fan
Dial to the
setting, and unplug from the electrical outlet.
NOTE: The Heater will cycle ON and OFF to maintain this temperature.
This is normal.
NOTE: To prevent the Heater from cycling, turn the Thermostat Dial to a
lower setting.
5
LO Heat / 750 Watts
OFF position, turn the Thermostat Dial to the minimum
OFF position before operating.
HI Heat / 1500 watts
HI Heat.