Advertisement
Image 2-4
2. Push the Lamp House forward until it slides fully into the projector. The positioning pins must match the holes in the Lamp House.
3. Secure the 3 captive screws on the Lamp House.
Image 2-5
4. Install the right projector cover. See the installation manual of the projector.
5. Plug in the power cord at the projector back side.
Note: While starting up the projector, the electronics detect if a Lamp House is installed. If no Lamp House is installed, it is not
possible to start up the projector.
2.3
Realignment of the lamp in the Lamp House
W
ARNING
It is recommended to realign the Z-axis of the lamp after the first run time of 100 and 200 hours.
R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011
:
The procedures below may only be performed by Barco trained and qualified technicians.
2. Lamp and Lamp House
7
Advertisement
