Advertisement
2. Lamp and Lamp House
Image 2-2
5. Take the Lamp House by its handles and pull it out of its compartment.
Image 2-3
Note: While starting up the projector, the electronics detect if a Lamp House is installed. If no Lamp House is installed, it is not
possible to start up the projector.
2.2
Installation of the Lamp House
W
ARNING
Necessary tools
7 mm flat screwdriver
How to install the Lamp House?
1. Take the Lamp House by its handles and gently slide it in its compartment.
Tip:
The compartment is provided with a guide to position the Lamp House correctly.
6
:
The procedures below may only be performed by Barco trained and qualified technicians.
R5905109 LAMP HOUSE WITH 2.5 KW LAMP 21/09/2011
Advertisement
