Related Manuals for Sun Microsystems Netra 150
Summary of Contents for Sun Microsystems Netra 150
- Page 1 Netra 150 Server Product Note A Sun Microsystems, Inc. Business 901 San Antonio Road Palo Alto, , CA 94303-4900 Part No: 802-7556-10 Revision A, February 1997...
- Page 2 USA 650 960-1300 fax 650 969-9131...
- Page 3 Netra 150 Server Product Note Part No: 802-7556-10 Revision A, February 1997...
- Page 4 52.227-14(g)(2)(6/87) and FAR 52.227-19(6/87), or DFAR 252.227-7015(b)(6/95) and DFAR 227.7202-3(a). Sun, Sun Microsystems, the Sun logo, and Solaris are trademarks or registered trademarks of Sun Microsystems, Inc. in the United States and in other countries. All SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International, Inc.
-
Page 5: Table Of Contents
Booting a Netra 150 Server with a Configuration Diskette 2 Time Taken for New Disk to Sync 3 Devices Can Only be Connected to Serial Port A on the Netra 150 Server 3 Powering Off the Netra 150 Server 4... - Page 6 Netra 150 Server Product Note ♦ Revision A, February 1997...
-
Page 7: Netra 150 Server Product Note
This document contains the late-breaking news for the Netra 150 server. Proper Ordering of Bay Disk Drives In the Netra 150 Server Service Manual , the instructions for installing a bay disk drive say to install the disks from top-to-bottom, left-to-right. These instructions are incorrect;... -
Page 8: Product Information
Booting a Netra 150 Server with a Configuration Diskette Whenever you boot your Netra 150 server, it will look for the configuration information for your site in one of two places: 4 If you have a diskette with your configuration information inserted in the Netra 150 server diskette drive, the server will automatically boot using the configuration information stored on that diskette. -
Page 9: Time Taken For New Disk To Sync
4 If you do not have a diskette inserted in the Netra 150 server diskette drive, the server will boot using the configuration information stored on the Netra 150 server system hard drive instead. When you boot your Netra 150 server, you should remove the configuration diskette from the diskette drive so that the system will boot using the configuration... -
Page 10: Powering Off The Netra 150 Server
Netra 150 server. To completely power off the server, the power switch located on the back of the Netra 150 server must be used. This is the switch for the server. Turning this switch to the off position will actually turn off the power to the server. -
Page 11: Performing A Cold Boot Causes Inherent Delays
Installing a Netra 150 Server in a Generic (Non-Sun) Cabinet It may be possible for you to install a Netra 150 server in a cabinet that you bought from a company other than Sun Microsystems as long as the cabinet is between 30”... - Page 12 3. Measure the distance between the lip on the long bracket and the end of the short bracket/slide assembly and extend the two brackets until the distance between the ends of the two brackets equals the distance between the side rails on your rack. Netra 150 Server Product Note ♦ Revision A, February 1997...
- Page 13 Expansion Cabinet and Powering On the Expansion Cabinet (pages 2-16 through 2-22) apply to Sun cabinets only; refer to the manual that you received with your generic cabinet for instructions on cabling, replacing the outer panels and powering on your cabinet. Netra 150 Server Product Note...