LFO Frequency
All four LFOs are linked and share a common frequency.
LFO Frequency can be set by holding the Scatter button and adjusting the Inertia knob.
When the Inertia knob is fully counter-clockwise, the LFO frequency will be 0.03Hz (30
seconds).
When the Inertia knob is fully clockwise, the LFO frequency will be 1kHz (1ms).
LFO Relationships
Holding the Scatter button and turning the Memory knob will change the relationship of the
LFOs.
Upon any change to the LFO relationship, the LEDs will light up green to indicate the
selected relationship on the top row of LEDs. This indication will persist until the Scatter
button is no longer held down.
Phase relationships:
• Phase Offset - Each Channel is 90 degrees out of phase with adjacent channels.
• Alternating - Channel 1 + 3 and 2 + 4 have same phase. Even channels are 180
degrees out of phase.
• Cascading - Each LFO performs one cycle and progresses to the next channel.
• Synchronous - All LFOs are phase synced with each other.
LFO Edit Functions
Resetting Internal Modulation
To reset the LFOs to their default state, hold the Scatter button and click the Terminal
encoder.
All LEDs will blink blue to indicate the LFOs are being reset.
13