Advertisement
2. Build phase bungee hook and servo installation
Bungee hook
Deburr bungee hook edges and add a radius
where the bungee cord ring will touch.
Roughen gluing surfaces according to picture.
Cut a ~3-4 by 12-13mm opening, 3mm from
the nose with a Dremel. Remove the material
al the way to the upper surface skin. Roughen
the surface around the cut out to ensure
proper bonding.
Glue bungee hook with gluing epoxy
1Wing
Martin Stobbe
Am Kuchelberg 2
82266 Inning am Ammersee
info@onewing.de
www.onewing.de
Advertisement
