Summary of Contents for 1Wing XBow2
- Page 1 Build instructions XBow² 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2 82266 Inning am Ammersee...
- Page 2 Please follow local law and make sure to have suitable insurance. 1Wing is not able to ensure proper build and safe operation and thus does not take liability for any material or non-material damage resulting from using their products.
- Page 3 1x 8x6x38mm 4. Tail boom (1 spare) 2x 10x9x100mm 5. 2x carbon control horns 6. Carbon bungee hook 7. 3x 60g self-adhesive weight 8. Carbon sheet material for hatches 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2 82266 Inning am Ammersee...
- Page 4 The front surface of the horn shall be flush with the flaps edge. The horn shall be directly bond to the lower outer skin of the wing. Ensure proper alignment and secure with tape. 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2 82266 Inning am Ammersee...
- Page 5 Make sure the tail boom is straight in longitudinal direction. Up/down is not too important since there is no horizontal stabilizer. Let all adhesions cure over night. 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2 82266 Inning am Ammersee...
- Page 6 Dremel. Remove the material al the way to the upper surface skin. Roughen the surface around the cut out to ensure proper bonding. Glue bungee hook with gluing epoxy 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2...
-
Page 7: Servo Installation
Apply gluing epoxy to all gluing surfaces. Install linkages and secure servos in positions by tape or weights. Secure clevises by glue or soldering to the linkage rods. This will reduce slop significantly. 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2... - Page 8 Cut out the hatches with scissors and sand the edges to fit. Apply openings by Dremel for the slightly excessing servo horns. Apply hatches with silicone or clear tape. 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2 82266 Inning am Ammersee...
- Page 9 Remove weight from the front in 5g steps until flying gets more nervous on the elevator and it gets harder to fly a straight line. Add 5-10g to the nose again and you are done. 1Wing info@onewing.de Martin Stobbe www.onewing.de...
- Page 10 8mm up / 4mm down Elevator 0.7mm up 30% expo Throws: 5mm up / 3mm down 30% expo We wish you always happy landings and a lot of fun with the XBow²! 1Wing info@onewing.de Martin Stobbe www.onewing.de Am Kuchelberg 2 82266 Inning am Ammersee...