Bus And Port Connections - Honeywell Centra Line EAGLE Installation & Commissioning Instructions

Bus and Port Connections

WARNING
Risk of electric shock or equipment damage!
Do not touch any live parts in the cabinet!
►
Disconnect the power supply before making connections
►
to or removing connections from terminals of the EAGLE
Controller or Panel Bus I/O modules.
Do not reconnect the power supply until you have
►
completed installation.
Observe the rules regarding electrostatic discharge.
►
8
1 2 3 4
24 25 26 27 28 29 30 31 32
1 2 5 6
Fig. 2. Bus and port connections, LEDs (top view)
8
1
J1 J8
2 3
Fig. 3. Bus and port connections (side view)
Legend
1 RS232 / RJ45 socket (for factory debugging, only)
2 USB 2.0 Host Interface (for connection of external
communication interfaces, e.g., the IF-LON)
3 ETHERNET / RJ45 socket (CLEA2000Bxx and
CLEA2026Bxx, only)
4 RS485-1 (isolated)
5 RS485-2 (non-isolated)
6 LEDs (see also Fig. 9)
7 USB 2.0 Device Interface (for connection to CARE /
XW-Online)
8 Slide switch (for setting bias and termination
resistance of RS485-1)
EAGLE CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
5 6
33 34 35 36 37 38 39 40 41 42 43 44 45 46 47
L1 L2 Tx Rx
7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22
USB 2.0 Host Interface
Via its USB 2.0 Host interface, the EAGLE Controller can be
connected to, e.g., the IF-LON External Interface Adapter and
thus to L W
ON ORKS
Interface Adapter – Mounting Instructions (EN1Z-0974GE51).
7
USB 2.0 Device Interface
All models of the EAGLE Controller are equipped with a USB
2.0 Device Interface at the front.
!
23
32 33 34 35 36 37
A standard USB type-B connector can be inserted into this
USB 2.0 Device Interface. This USB 2.0 Device Interface is
the recommended interface for connection to CARE.
5
networks. See also IF-LON External
USB 2.0
Host Interface
Fig. 4. USB 2.0 Host interface
38 39 40 41 42 43 44 45 46 47
USB 2.0
Device Interface
Fig. 5. USB 2.0 Device Interface
EN1Z-0970GE51 R1112