Page 1
Trada 2-Leg ™ Assembly instructions Electric height adjustable table base Model # 2TD-C48-24-___ Model # 2TD-C48-30-___ ___ = SLV, BLK or WHT...
Trada 2-leg Components and tools Caution • Do not use impact drivers or other high-torque equipment. Use power drill on self-tapping wood screws only. table • Always check that screws used to attach components to the worksurface thickness are not too long for the thickness of the table. The provided screws require a minimum table thickness of 1.0".
Trada 2-leg Assembly Step #1: attach legs to crossbars • Position the two legs and crossbars as shown. — Position the exposed inner channel of the crossbars against the front of the right motor housing and against the rear of the left motor housing.
Page 4
Trada 2-leg Assembly Step #3: attach universal side brackets to crossbars • Turn the table upright so that it rests on the two feet. • Using a #3 Phillips screwdriver, attach the universal side brackets to the crossbars with the –20x...
Page 5
Trada 2-leg Assembly Step #4: adhere bumpers onto crossbars Rubber bumpers help protect against worksurface damage and ensure smooth up-down operation. The bumpers are self-adhesive. Simply peel the backing and press the bumpers into position. • Adhere one round rubber bumper midway between the motor housings on each crossbar.
Trada 2-leg Assembly Step #5: position assembled frame on underside of worksurface With the table top facing down on a soft, clean surface, turn the assembled frame upside-down and center it on the underside of the worksurface. • Use a 3mm Allen key to loosen the set screw on each crossbar near the end where the exposed channel begins.
Page 7
Trada 2-leg Assembly Step #7: screw side brackets to worksurface • Align the rear of the feet with the rear edge of the table • Double-check that the frame is centered side-to-side. • Screw the side brackets to the table using two #10x1" wood screws per bracket.
Trada 2-leg Assembly power power cord power supply supply holder motor cable power supply cable motor cable handset cable control unit " Phillips round head handset Step #9: attach handset • Position the handset on either side of the table (user preference). NOTE: With the table face-down, the left side will be the right side when the table is turned upright.
— Unplug the power cord. • If there is a problem with operation, check that all cable and cord connections are secure. Check to be sure the AC outlet has power. If problems continue, call ESI Customer Service: 800.833.3746. NOTICE: With the table upside-down, the DOWN t button points up and the UP s button points down.
Page 10
Trada 2-leg Operation general operation • Move the table by pressing the UP s button to raise it and the DOWN t DOWN t button to lower it. button UP s • The table will continue to move up or down until you release the button,...
Page 12
LIMITED WARRANTY ESI warrants this product to be free from defects in manufacturing for a period of 15 years on structural parts and 7 years on electrical parts from the date of original purchase. This warranty extends only to the original purchaser, and does not apply if the product has been damaged or fails to function properly as a result of misuse, abuse, modification, alteration, or improper cleaning or maintenance.