Page 1
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
Seller’s obligation under this warranty is limited to the repair of defects without charge by a Wells Mfg. Co. factory authorized service agency or one of its sub-service agen- cies.
PARTS & SERVICE CUSTOMER SERVICE DATA Thank You for purchasing this Wells Manufacturing Co. appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
This appliance is intended for use in commercial establishments only. This appliance is intended to prepare food for human consumption, and to hold that food at temperature for serving. No other use is recommended or authorized by the manufacturer or its agents. Operators of this appliance must be familiar with the appliance use, limitations and associated restrictions.
INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation. Refer to SHIPPING DAMAGE CLAIM PROCEDURE on the inside front cover of this manual. CAUTION: RISK OF DAMAGE...
PREPARATION Scoop any remaining popcorn from cabinet and discard. Empty crumb tray. Be sure inside of kettle is wiped clean, and the stirrer wand is properly installed. Press the WARMER switch “ON”. The heat lamp and cabinet base heater will come on. Preheat for kettle 7 minutes before popping the first batch.
CLEANING INSTRUCTIONS CAUTION: ELECTRIC SHOCK HAZARD Disconnect unit from electric power before cleaning. CAUTION: BURN HAZARD Allow unit to cool completely before cleaning. IMPORTANT: DO NOT spill, splash or pour water into controls, kettle receptacle, heat lamp socket or wiring. IMPORTANT: DO NOT use steel wool or abrasive cleansers for cleaning the...
PROBLEM Power cord unplugged Circuit breaker tripped No power to unit Power cord or plug damaged Kettle switch OFF Kettle plug not securely plugged into twist- lock receptacle Does not pop popcorn Damaged kettle switch Damaged kettle internal components Some brands of popcorn, or popcorn that is out-of-date may not pop completely.
MAINTENANCE INSTRUCTIONS CAUTION: INJURY HAZARD Disconnect appliance from electrical power before performing any of these procedures. Adjust Positioning Cam CAUTION: BURN HAZARD Lamp may be hot. Allow lamp to cool before replacing Change Heat Lamp ADJUST STIRRER NEUTRAL POSITION With the kettle switch OFF, the stirrer should land at a position that allows the kettle to rotate without binding on the stirrer wand.
IMPORTANT: Use only factory authorized service parts and replacement filters. For factory authorized service, or to order factory authorized replacement parts, contact your Wells authorized service agency, or call: Wells Manufacturing Co. 2 Erik Circle P. O. Box 280 Verdi, NV 89439...