Operating Instructions - Weil-McLain CGa User's Information Manual

Lighting instructions
• Standing pilot
• Gas valve — Robertshaw 7000DERHC
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance has a pilot, which must be lighted
by hand. When lighting the pilot, follow these
instructions exactly.
B. Before , smell all around the appliance
LIGHTING
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor. See below.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
1. Read the safety information above on this label.
Stop!
2. Set the thermostat to lowest setting.
3. Turn off all electrical power to the appliance.
4. Depress gas control knob slightly and turn clockwise
to .
OFF
59205
Note: Gas control knob cannot be turned to
depressed slightly. Do not force.
5. Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas,
in the safety information above. If you don't smell
"B"
gas, go to the next step.
6. Remove access panel located above burners.
7. Find pilot — follow metal tube from gas
control. The pilot is between two burners
behind the access panel.
1. Set the thermostat to lowest setting.
2. Turn off all electric power to the appliance if service is to
be performed.
3. Remove front panel.
Part Number 550-110-592/1099
If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
C. Use only your hand to depress or turn the gas control knob. Never
D. Do not use this appliance if any part has been under water.
WHAT TO DO IF YOU SMELL GAS

OPERATING INSTRUCTIONS

Gas control knob
(shown in ON position)
Position
indicator
unless knob is
OFF
Follow
STOP!
TO TURN OFF GAS TO THE APPLIANCE
EG-75, EGH-85, EGH-95,
PFG-6, PFG-7
use tools. If the selector arm will not depress or move by hand, don't
try to repair it, call a qualified service technician. Force or attempted
repair may result in a fire or explosion.
Immediately call a qualified service technician to inspect the appliance
and to replace any part of the control system and any gas control,
which has been under water.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
8. Turn gas control knob counterclockwise
9. Depress gas control knob and hold. Immediately light the
pilot with a match. Continue to hold gas control knob in
for about one (1) minute after the pilot is lit.
• If pilot can be lit without depressing gas control knob,
turn gas knob clockwise
vice technician or gas supplier.
10. Release gas control knob. Pilot should remain lit. If pilot
goes out, repeat steps 4 through 10.
• If gas control knob stays depressed after release, stop
and immediately call your service technician or gas
supplier.
• If the pilot will not stay lit after several tries, turn the
gas control knob clockwise
service technician or gas supplier.
11. Replace access panel.
12. Turn gas control knob counterclockwise
13. Turn on all electric power to the appliance.
14. Set thermostat to desired setting.
15. Replace front panel.
59337
4. Depress gas control knob slightly and turn clockwise
to .
OFF
5. Replace front panel.
to .
PILOT
to and call your ser-
OFF
to and call your
OFF
to .
ON
15